![]() Good heavy duty top makes for a stable unit. Convenient on-board storage for all accessories so nothing becomes lost. Small and light weight will fit onto a bench for use, then light enough to put away afterwards. Great entry level oscillating spindle sander. These sizes will provide the needed diameters for most sanding jobs. It comes with three rubber spindle sizes at ¾, 1, and 1½. The WEN oscillating sander has a powerful 3.5 amp motor that runs at 2000 revolutions per minute. The sanding sleeves provided are 13mm, 19mm, 26mm, 38mm, 51mm, 76mm with a length of 115mm. This spindle sander features adjustable speeds between 1,800 and 3,200 RPMs and oscillation rates between 50 and 90 strokes per minute. Triton have also provided on-board storage for all accessories to assist in keeping them safe as well as a dust port of dust extraction. Shop spindle sanders and oscillating spindle sanders from Jet, Laguna Tools, Rikon, and 900+ other top tool brands. Included are 6 sanding sleeves from sizes 1/2” to 3” with the appropriate table insert to provide the right amount of work support and efficient dust extraction. This oscillating action is powered by a sturdy 450W motor. When properly cared for, this product will supply you years of rugged, trouble-free performance. #OSCILLATING SPINDLE SANDER MANUAL#The rotating and oscillating action extends the life of the sanding sleeve, while at the same time not burning the timber by not having the same part of the sleeve in constant contact with the material. WEN AT6510 Oscillating Spindle Sander Instruction Manual IMPORTANT: Your new tool has been engineered and manufactured to WEN’s highest standards for dependability, ease of operation, and operator safety. Solid plastic deposits cannot be removed from the spindle with the big natural rubber stick this just wastes rubber.This oscillating spindle sander has a heavy duty table, giving it stability with decent material support.White plastic-sanding dust must be removed from the spindle as soon as possible.Periodically cleaning the abrasive with the big natural rubber stick extends the life of the spindle.Do not over tighten the nut is 12 mm, wrench hanging on the side When changing sandpaper sleeves, the compression nut on the top is also left handed. When changing drums, it takes (2) 17 mm wenches (hanging on the side) and since it is a left had thread, turn clockwise to remove. If you have to use force to press your workpiece into the spindle, the abrasive is worn out (and unsafe). Let your workpiece touch the spindle and have the spindle do the work.Don't sand or leave anything wet unless you meticulously clean up afterwards, the table will rust. Oscillating Spindle Sanders Oscillating Spindle Sanders Sanders JET Oscillating Spindle Sanders are durable and powerful.This means your aluminum workpiece is capable of scraping the grit off of the paper, which ruins the abrasive. Structural aluminum alloys are harder than the adhesive used to hold the grit to the paper. Only do touch-up sanding, not bulk material removal. When sanding aluminum, use the lightest possible pressure.If you leave plastic dust on the spindle, it can melt and ruin the abrasive when the next user sands wood. Make sure to clean all traces of plastic dust from the spindle when you are done. If the contact temperature gets hot enough to melt the plastic, solid plastic deposits will block the grit and the abrasive will be ruined. When sanding plastic, use the lightest possible pressure.Within limits (see below), plastic and aluminum can also be sanded. A very versatile tool good for removing small amounts of material and splinters. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |